Pour the herb wood carvers and professionals, a carving station is an easy way to keep a constant piece, as you can cut. Using a large panel to engage with different ways, the work is not new, but the smaller version is easy to make and extremely versatile. You only need a piece of plywood smooth and thick, 14-in. 28-in., And scraps of plywood and hardwood.
Different sides of the plate to adapt to different tasks. One side has fencing and various fillerscontaining irregularly shaped pieces in place using a pair of wedges or cams. The flat side can be screwed to an empty plate-backed through the plywood. Mark the length and width of the center lines in pencil on the flat side, because they are very useful for the bolts, and aligning spaces. Even for the work that is symmetrical curved silhouette, you can design a system of grid lines on the plywood.
On page four precincts that is screwed and glued to it, third placefences in the margins of Set 1.5-in. or so. Set the fourth wire fence to the edge of the plywood base. The fence provides the most widely used one long side, the ideal place for holding pieces of form, and creates the flanges on the short sides allow you to back up the carving station at a desk or table.
Many wood carvers to sculpt detailed work better on an incline so that the work significantly without having to bend. I made a tripod tiltedthat fits into the side of the fence carving station. The ends of two right triangles are 30/60 from 3-in. Plywood, with two rectangular pieces connected triangles overlap. The triangles are fences in short form on the base. I also notched to fit the ends of the two fences along.
No comments:
Post a Comment